/ Home
/ SUBMISSION

/ The BJNANO
/ Diamond Open Access
/ Journal Statistics
/ Editorial Board
/ Community
/ Call for papers

/ Latest Articles
/ Most accessed
/ Thematic issues
/ Volumes
/ Authors

/ Alerts

/ TWITTER
/ LINKEDIN
/ Mastodon
/ RSS FEED

Empty search

Article Type

Publication Date Range

Search Tips

This search combines search strings from the content search (i.e. "Full Text", "Author", "Title", "Abstract", or "Keywords") with "Article Type" and "Publication Date Range" using the AND operator.

Search Examples

aromatic	the word “aromatic”
aromatic aldehyde	the word “aromatic” OR “aldehyde”
+aromatic +aldehyde	both words “aromatic” AND “aldehyde”
+aromatic -aldehyde	the word “aromatic” but NOT “aldehyde”
“aromatic aldehyde”	the exact phrase “aromatic aldehyde”
benz*	words which begin with “benz”, such as “benzene” or “benzyl”
benz*yl	words that begin with “benz” and end with “yl”, such as “benzyl” or “benzoyl”
benzyl~	words that are close to the word “benzyl”, such as “benzoyl” (i.e., fuzzy search)

BROWSE
Latest Articles
Most accessed
thematic issues
volumes
authors

BROWSE

Latest Articles Most Accessed Thematic Issues Volumes Authors

Author

2 article(s) from Matteini, Paolo

Low cost tips for tip-enhanced Raman spectroscopy fabricated by two-step electrochemical etching of 125 µm diameter gold wires

Antonino Foti,
Francesco Barreca,
Enza Fazio,
Cristiano D’Andrea,
Paolo Matteini,
Onofrio Maria Maragò and
Pietro Giuseppe Gucciardi

Beilstein J. Nanotechnol. 2018, 9, 2718–2729, doi:10.3762/bjnano.9.254

PDF

Figure 1: (a) Experimental setup. (b) Details of the tip immersion zone, highlighting the geometry and positi...

Jump to Figure 1

Figure 2: Temporal evolution of the two step electrochemical etching process. (a) A meniscus is formed at the...

Jump to Figure 2

Figure 3: (a) SEM images of a pilum-shaped tip with details shown in (b), (c) and (d) on the apical part, sho...

Jump to Figure 3

Figure 4: (a) SEM image of a tip highlighting the dimensions of the tapered zones. The dashed lines are a con...

Jump to Figure 4

Figure 5: (a) SEM image of an etched tip (t₁ = 20 s, V₁ = 5 V_DC, t₂ = 75 s, V₂ = 2.1 V_DC) and details on its ...

Jump to Figure 5

Figure 6: (a) Sketch of the scanning configuration for the mapping of the light emitted by the tip. The tip i...

Jump to Figure 6

Figure 7: TERS spectra (colored lines) of different molecules acquired with the tip in contact with the surfa...

Jump to Figure 7

Figure 8: TERS signal of oligomers when the STM feedback loop is on (red line) and when it is off (black line...

Jump to Figure 8

Figure 9: (a) STM image of Au(111) terraces on which R6G 10⁻⁴ M is adsorbed (∆V = 0.05 V – tip positive, curr...

Jump to Figure 9

Figure 10: (a) TERS map and point spectra (b) acquired at the locations indicated with the labels 1, 2, 3, at ...

Jump to Figure 10

Album

Supp Info

Full Research Paper

Published 22 Oct 2018

Full text

Controlled graphene oxide assembly on silver nanocube monolayers for SERS detection: dependence on nanocube packing procedure

Martina Banchelli,
Bruno Tiribilli,
Roberto Pini,
Luigi Dei,
Paolo Matteini and
Gabriella Caminati

Beilstein J. Nanotechnol. 2016, 7, 9–21, doi:10.3762/bjnano.7.2

PDF

Figure 1: Procedure A. Formation of AgNC arrays by means of the Langmuir–Blodgett technique. (a) π–A and C_s⁻¹...

Jump to Figure 1

Figure 2: Procedure B. Formation of AgNC arrays by means of sequential physisorption. Δf₃/3 (black curve, lef...

Jump to Figure 2

Figure 3: Change in Δf₃/3 (black curve, left y-axis) and ΔD₃ (blues curve, right y-axis) upon addition of gra...

Jump to Figure 3

Figure 4: Optical images of GO-covered AgNCs prepared with procedure A (a) and B (b).

Jump to Figure 4

Figure 5: (a) AFM image of GO-covered silver nanocubes obtained from Langmuir–Blodgett transfer at 15 mN/m. (...

Jump to Figure 5

Figure 6: SERS spectra of Adenine (9 × 10⁻⁷ M) adsorbed on single LB layer of AgNCs (B), on GO/AgNCs obtained...

Jump to Figure 6

Figure 7: SERS spectra of Adenine (9 × 10⁻⁴ M) adsorbed on GO/AgNCs obtained with procedure A (red curve) and...

Jump to Figure 7

Figure 8: Checkboard model for AgNCs arrays on SiO₂ obtained with procedure A (surface density = 41 NC/μm²) a...

Jump to Figure 8

Album

Supp Info

Full Research Paper

Published 06 Jan 2016

Full text

Other Beilstein-Institut Open Science Activities

/ Help / Support & Contact / Alerts / Privacy Policy / Terms & Conditions / Impressum